What You Should Know About Fire Hose Pipe?

There are two types of fire hose pipe available. These are known as the supply and relay hoses. They are used to convey water from a fire hydrant to a fire pumper. The supply and relay hoses have a wide range of nominal inside diameters, from 3.5 inches to 5.0 inches (89-127 mm). Each has a fixed length of about 100 feet and is suitable for long distances.

When installing a fire hose, you need to understand how it fits together. The threading on the couplings is important for a proper connection. You should look for the stamp with initials on the hose couplings. Also, make sure to check with the local fire department about the proper threading. While it may seem difficult at first, there are three primary thread types, and the local fire department can guide you.

The pressure within the hose is measured in pounds per square centimeters. This measurement reflects the amount of pressure that it can handle. A fire hose that has been manufactured with double-jacket rubber lines should pass the National Fire Protection Association's minimum standards. This includes pressure-testing the hoses at 600 and 800 psi. Fire hoses must be tested annually, and they must meet standards to avoid accidents or damage.

Fire hoses must be long enough to reach the fire. Any damage or tear will reduce the effectiveness of the hose. However, minor punctures and tears can be patched. A fire hose with a catastrophic tear cannot be repaired. This is especially important for small-scale fires where the amount of water needed is small. This makes a fire hose more expensive to replace. If your hose is damaged, make sure to replace it with a new one.